More than 200 commands in six modules. Each module is a separate plug-in, so the ribbon shows only what you use.
A model is built from an outline or from samples. Cells are coloured by grade, and reserves are calculated by level and domain.
Open →12 commandsDrillholes are shown as tubes coloured by interval. The interval table is edited right in the program.
Open →64 commandsFrom the hole grid to the blast plan. Charging rules, delay pattern, powder factor and safe distances.
Open →33 commandsWireframes are built from points and lines, checked and repaired. Contours and sections are then taken from them.
Open →23 commandsScans and drone surveys are imported whole. The ground is separated from everything else, then benches are found on it and volumes calculated.
Open →45 commandsThe familiar CAD toolset with mining geometry: graded alignments, points at a step and projection onto a surface.
Open →The demo is the full program: all six modules, nothing switched off. Windows 10 or 11, 64-bit.
